• Matt finish is recommended for applications that require a pastel non-reflective look. (Please note: some very dark colours or black may look lighter or more gray with this finish)
• This standard (Type A) suits all solid and particulate colours except colours with a degree of translucency or veining.

Works are to be completed by a fabricator that is licensed to use the specified product. All joins to be totally seamless and extremely hard to see (almost invisible) without any joint contamination, voids or dirty looking lines. Tops and panels will be finished to matt finish with a gloss rating of 30%. All surfaces must be a consistent and uniform finish without blotchy swirl marks. Edge build-ups are to be as per the details outlined in the final approved drawings and to be a constant uniform finish with all saw marks removed from the underside. Either an off cut of the same batch is to be supplied with the finished product or preferably the fabricator should offer an offsite holding service for the off cut. All cut outs must be routed and sanded smooth Note: Jig saws are not to be used on cutouts. All hotplate cutouts must be routed on 45°, sanded and covered with heat reflecting tape. No scratches are to be present on completion of the fabrication/ installation.